Pipe Bending for High-Frequency Induction

>> High-Frequency Pipe Bending * Features of High-Frequency Induction Bending + The quality of induction bends is good K-TRADE induction bends being made by a compression bending technology the quality of it is good in such points that a pipe wall reduction rate and an ovality rate are smaller than those of other induction bending products. + Small-R pipe (1.5DR~2DR) K-TRADE has capacity for Small-R pipe bend and supplied to shipboard and plants piping. +Large-R pipe(3DR, 5DR, 7DR) 1. Outside Diameter : 25A (1 inch) ~ 1200A (48 inch) 2. Bending Radius : Min. 2DR, Max No limit. 3. Bending Angle : Max. 270° 4. Pipe Length : Max. 15,000mm 5. Pipe Material : Carbon Steel, Stainless Steel, High Alloy Steel, Copper Alloy, Aluminum, Titanium, Monel Metal, etc. + Any form of induction bends is available K-TRADE induction bends being made without any mould it is free and in any form of which is single, double and three dimensional bending and also it is possible to select any bending radius and angle desired within the limit of the bending machine capacity. + Piping cost can be saved K-TRADE induction bends reduce the welds in pipeline it leads the cost saving in piping material and installation.